Configure CLIP on Analog Trunks

Home Forums Unified Communications MiVoice Office 400 Configure CLIP on Analog Trunks

This topic contains 2 replies, has 2 voices, and was last updated by  Curtis Richardson 7 months, 3 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #4939

    Curtis Richardson
    Participant

    According to the KB article, the Mitel 400 has the ability to send out caller ID on both SIP and PRI trunks. The KB article does not mention if this can be done on analog trunks. Can caller ID be changed when the 470 is connected to analog trunks?

    I doubt it can but I’d figure I’d ask.

    Thanks,
    Curtis

    #4956

    Francois Ouimet
    Participant

    HI Curtis, on the analog trunk, who is deciding to send or not the caller ID is the carrier
    all PBX platform we have are doing the same, the Carrier is the one to check if they can or not
    normally yes we send the caller ID
    but is not a PBX feature for the analog trunks

    Francois

    #4958

    Curtis Richardson
    Participant

    Thank you Francois!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.